POD14A — Dual Analog To Digital Converter

DIGITAL REFERENCE INPUT Input Impedance 75Ω or 110Ω Input Level 0.2-7V p-p Sampling Frequency Range 32kHz to 192kHz

ANALOG AUDIO INPUT

Input Impedance 24kΩ balanced Maximum Input +24 dBu Frequency Response ± 0.1 dB, 20Hz to 20kHz

DIGITAL AUDIO OUTPUT Resolution 24 bits Output Standard AES/EBU 75Ω unbalanced and 110Ω balanced External Sampling Frequency 32kHz to 192kHz Internal Sampling Frequency Selectable 32, 44.1, 48, 96 and 192kHz Jitter less than 5 ns Level 1 Vp-p terminated Noise better than -115 dBFS, 20Hz to 20kHz Typical unweighted Total Harmonic Distortion + Noise better than 0.01%

GENERAL Power Requirements 100-240 VAC,50-60 Hz

6 Watts Dimensions 8.69" wide x 1.73" high x 7.0" deep

(221mm x 44mm x 178 mm) Weight 3.01 lbs (1.37 kg)

All the preceding specifications were taken with a 48 kHz external reference.

Also: specs boilerplate (56 devices)

Front panel controls and tallies include a power switch with LED tally, a momentary step switch and LED indicators to cycle through the internally generated sample rates from 32 to 192 kHz. Two LEDs that indicate whether the external or internal reference is used. The external sampling rate reference signal has precedence over the internally generated signal. As soon as an external reference signal is detected, POD14A will automatically switch to it.

REAR PANEL

Connections to POD14A are made on the rear panel. Analog inputs are via 3-pin Phoenix® pluggable connectors, connections to the digital reference and two digital outputs may be made by using the Phoenix® 3-pin pluggable connectors for balanced 110 Ohm installation or BNCs for unbalanced 75 Ohm installation. Level trim controls for analog input signal level control are located adjacent to the analog input connectors. The AC power cord and Fuse are also located on the rear panel.

SETUP

There are no special setup procedures necessary prior to using POD14A. Simply plug the unit into an AC power outlet and connect input and output cables. POD14A is factory calibrated to output a nominal -20dBFS digital signal when a +4 dBu signal is applied at the analog inputs. The input trim controls may be used to set POD14A up for a different nominal digital output signal

(only shared text)

Also: warranty boilerplate (67 devices) · warranty boilerplate (67 devices) · warranty boilerplate (67 devices) · warranty boilerplate (67 devices) · warranty boilerplate (67 devices) · warranty boilerplate (67 devices) · warranty boilerplate (67 devices) · warranty boilerplate (67 devices) · warranty boilerplate (67 devices) · warranty boilerplate (67 devices) · warranty boilerplate (67 devices) · warranty boilerplate (68 devices)